How To Remove A Car Lock

Having your own car can be such a rewarding thing for you.

At the same time, having responsibility goes along with it.

You have to be knowledgeable on some things about your car.

Like fixing, replacing, and even removing things on your car.

Specifically, the cars’ lock.

A car lock is responsible for locking and unlocking your car door.

It is one of the most important parts of your car.

If your car lock is broken, it is easier for thieves to steal it.

Broken car locks can have several causes.

One is, low quality of the car lock itself.

Some car models have poor quality car locks that can be broken immediately.

Another reason for broken car locks is the dirt.

Things that can cause car locks to be dirty are sand, dust, and even cement.

Dirty things can’t function easily just like car locks.

Too much heat or frost can also be the reason for car locks to be broken.

Lastly, for some situations, forced break-in is another reason for crushed car locks.

These reasons can lead to a variety of results as well.

Number one result is key malfunction.

Which means that the keys do not respond to the car door lock properly.

Another reason is the keys do not fit to the door lock anymore because it is crushed or broken.

In most cases, the ignition lock just continues to turn.

If any of these things happen, it can only mean one thing.

You must do something about your car lock immediately.

In this passage, we will try to teach you how to remove a car lock.

Put your Car Door Panel Aside

The first thing you should put in mind is about your car door panel.

The very first step in removing car locks is to put aside your car door.

You should also place your ignition key in the proper position so you can raise your car windows up.

After raising your car window, take it off and put your door panel on the side gently.

This step is important because in this way, it will be easier for you to have access to your car lock.

Elevating the Car Window Up

Second step is you need to place your ignition key again to elevate your car window up as high as possible.

This car window is already connected with a wire.

You can use a flat screwdriver to unplug these wires placed behind.

Remove Car Door Handle

In removing the car door handle, you must find its control rod and remove it carefully.

You can use Philips screwdriver in removing the car door handle from the door panel itself.

Gently pull off the handle and detach it from the rod.

Make sure not to leave any scratch.

Getting the Car Lock Control Rod Out

You also need a screwdriver for this step to successfully put out the lock control rod.

Calmly push down the clip from the control rod.

In this way, you are already removing the rod from the arm lock.

Eliminating the Car Lock

Finally you are on to your last step.

In this step you can use either a pick or a screwdriver.

Use either of these tools to dismantle the power clip.

A power clip holds the car lock inside the lock hole.

Once you do this, you can effortlessly remove the car lock because it is already loose.

Call for Mobile Locksmith

Removing Car Lock is such a difficult task.

It is also time-consuming and may cost you a lot of money.

But you can remove and fix your car lock in the shortest possible period of time.

You can achieve this by calling for help from a locksmith.

Although we already give you some steps on how to remove a car lock.

We highly suggest that you seek help from an expert.

Lucky you, Auto Goldy Locks Edmonton provides such service.

We are always available any day of the week.

Locksmith at Edmonton is quite skilled for this task.

We also offer services that are affordable and budget-friendly.

Auto Goldy Locks Edmonton makes sure that we offer service that meets satisfaction.

We are always on standby to help so do not hesitate to call us.

Rate this post
Contact Us
Our technicians are equipped with masks and gloves complying with health and safety regulations.
This is default text for notification bar